![]() ![]() Storage & Operating Ambient Temp.: -40☏ to +150☏ (-40☌ to +65☌) Moisture: 5 to 95% RH, non-condensing and non-crystallizing Oil Burner Input: < 20gph Control Programming: U元72 Group 2 Igniter: 120 Vac, 3 A 0.7 PF min Solenoid Valve: 120 Vac, 1 A 0.7 PF min Thermostat Anticipator Current: 0.1 A (If applicable) Thermostat Voltage: 24 Vac (If applicable) – Reduce motor FLA rating by igniter current ![]() Motor: 120 Vac, 10 full load amps (FLA*), 60 locked rotor amps (LRA) Voltage: 102 to 132 Vac Current: 150 mA plus burner motor, igniter, and valve loads Frequency: 60 Hz 2) Valve-on delay and motor-off delay timings on all models are programmable with Beckett snap-in programming display. See the table below:ġ) Beckett snap-in alarm module required for direct replacement of the control. The yellow light will fl ash 1 to 4 times depending on the amount of light detected by the cad cell. The burner will remain off as long as the button is held.ĭuring the burner Run state, click the reset button to check the cad cell fl ame resistance range. To reset, hold the button down for 15 seconds until the red light turns off and the yellow LED turns on.Īny time the burner is running, press and hold the reset button to disable the burner. If the control locks out three times without a satisfi ed call for heat or fails the motor relay check, the Lockout becomes restricted in order to prevent repetitious resetting by the homeowner. When fi nished, hold the reset button or remove the call for heat to exit Pump Prime mode and return to Standby. If necessary, repeat steps 4 and 5 until the pump is fully primed and the oil is free of bubbles. Bleed the pump until all froth and bubbles are purged. At burner start up, click the reset button while the igniter is still on to enter Pump Prime mode. The yellow light will turn off and the burner will start again. ![]() When the burner starts, press and hold the reset button for 15 seconds until the yellow light turns on. Unit 3 - 430 Laird Road, Guelph, Ontario, Canada N1G 3X7 ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |